Isothermal Plug Flow Tubular Reactor (Coiled Tube Type)
This set-up is used to study a non-catalytic homogeneous reaction under isothermal condition. The set up consists of two feed tanks through which two reactants are fed to the reactor. Rotameters are provided to measure the individual flow of Chemicals. The flow rate can be adjusted by operating the needle valves provided on respective Rotameter. The compressed air is used for circulation of feed. It is a helical coil tube type reactor kept in a constant temperature water bath to conduct the experiment at various temperatures. Reactants enter at lower end coming out of the top of coil from where samples are collected for analysis. Pressure Regulator, Pressure Gauge and Safety Valve are fitted in the compressed air line.
Technical Specification :-
|
Reactor |
Material Stainless Steel, Capacity 0.8 Ltrs. (approx) (Helical Coiled Tube Type) |
|
Water Bath |
Material Stainless Steel, Double wall, insulated with Ceramic Wool. |
|
Heater |
Nichrome wire Heater |
|
Stirrer(for Water Bath) |
Stainless Steel Impeller and shaft coupled with FHP motor. |
|
Feed Tank (2Nos.) |
Material Stainless Steel (2 Nos.), Capacity 20 Ltrs. with level indicators, air release valves, charging funnel with valve, air pressure fittings, feed lines, drain valve etc. |
|
Feed Circulation |
By Compressed Air, using PU pipe line & fittings Pressure Regulator Bourdon type (0-2 kg/cm2) |
|
Flow Measurement |
Rotameter 2Nos. (one each for Reactants) |
|
Temp. Sensor |
RTD PT-100 type |
|
Control panel |
Digital Temp. Controller: 0-200°C. RTD PT-100type (For Water Bath) On/off switch, Mains Indicator etc. |
You May Also Like
